WQC02 Suqare guide rail carriages-TPB - CSB® Plastic Bearing Technology

Product properties

● Sliding layer material: TEFPLAS® B

● Operation temperature ±200℃

● Max. continuous running speed 1.5m/s

● Maintenance-free, dry-running

● Mono-design and low cost

● For WQ double square guide rails

● Resistant dust and quiet

Standard products

WQC02 Suqare guide rail carriages-TPB

Part no.:

L [mm]：

C [mm]：

A [mm]：

A1 [mm]：

H [mm]：

K [mm]：

*Lead time [wks]：

Shop now

Dimensions

▊WQC02 Suqare guide rail carriages load capacity

Part No.	Static load					Weight
Part No.	Coy- [N]	Coz [N]	Mox [Nm]	Moy [Nm]	Moz [Nm]	[kg]
WQC02-06-30-060-TPB	9500	4800	70	140	140	0.07
WQC02-10-40-100-TPB	25000	12500	250	600	600	0.21
WQC02-16-60-100-TPB	42000	21000	600	1000	1000	0.40
WQC02-20-80-150-TPB	83000	41500	1700	3000	3000	1.00

▊Eccentric forces

● Maximum 2:1 ratio

● 1x = bearing separation on same shaft

● 2x = distance from shaft to load or force

CSB-LIN®直线轴承安装法则

● CAUTION: uneven motion or even system blockage will occur if the 2:1 ratio is exceeded !

This principle is NOT load dependent! It is NOT due to edge loading. It is also NOT dependent on the driving force used! The greater the distance between the drive and guide bearings, the higher the degree of wear and required drive force.

There may be other factors that add to the braking effect, but the coefficient of friction is the main cause.

● NOTE: The Rule(2:1) is based on the static friction value of 0.25 theoretically, However, Additional lubrication can help to drop friction and extend the 2:1 ratio.

● If you have any questions on design and/or assembly, please contact our application engineers.

no products

CSB-LMS® WQ Suqare linear guide rails

Type PDF

Size 196KB

Time 10-2022

No. CSB/CAT.062E

download

988

塑料直线轴承查找器 — CSB-LIN®

CSB-LIN® Plastic Linear Bearings Finder V2.0

view tools

▊CSB-LIN® Plastic Linear Bearings Finder[V2.0] including LIN plastic linear bearings and LINP precision linear bearings. The system is based on the analysis and calculation of a large number of test data in CSB® laboratory. You can calculations bearing data by entering parameters such as bearing load, speed, temperature and position information, The system will output bearing adaptation data and min. driving force.
▊Because the system calculate and analyze based on lab data, it can't exactly meet the ractual use requirements absolutly. The system data verification has certain limitations; CSB® recommends that the bearing must be tested again to verify whether it meets the actual use requirements.
▊CSB-LIN® Plastic Linear Bearings Finder output data information is only for design reference, and can not be used as the final standard for determining the bearing material conformity, If you have any questions, please contact CSB® sales engineers.